1. Structure and characteristic 
  

◎ Purpose :  It is applied to cutting oil tank for concentrated coolant system, in which a lot of waste  oil and floating sludge are generated. 
    
◎ Structure : Waste oil and other matters floated in clean tank is pumped and induced by the pump of floating skimmer. 
 Pumped sludge is separated and filtered by centrifugal separator or Mg separator located in the inlet of oil & water separator and pumped waste oil is separated from water-soluble cutting oil inside oil & water separator. After the process, waste oil is discharged to waste oil box and clean water is drained to clean tank again. 
 In addition, the fine sludge settled in the bottom of oil & water separator in the process is discharged to the outside by scraper conveyor.  
    
◎ Characteristic : It is possible to remove waste oil and other floating matters at the same time.  
  In case of AL cutting line, it displays outstanding performance in the removal of scum and sludge floating on clean water. 　 
In case of FC cutting line, it displays outstanding performance in the removal of carbon powder floating on clean water. 
 
  
2. TYPE BY WORK MATERIAL (FLOW SHEET) 
  
1) AL(nonferrous) material 

  
 
  
2) STEEL(FC, Forged steel, S45C) material  

  
 
  
3. Structural Part :  
A FIOATING SKIMMER 
 B. OIL & WATER SEPARATOR 
 C. AUTO SEPARATOR & Mg SEPARATOR. 
 D. CUTTING OIL SETERILIZATION UNIT AND CONTROL PANEL 
 E. SUCTION PUMP. 
 F. WASTE OIL TANK 
 G. SLUDGE BOX. 
 H. CUTTING OIL AND WASTE OIL PIPE 
  
4. Painting spec  
Main body : 2 times of heat treatments in 상, 하도 
Others : 1 times of heat treatments in 상, 하도 
Color : To be appointed by your company