Chat with us, powered by LiveChat Pusher (Ratchet Pusher) | Mag switch - Komachine
Product Name Pusher (Ratchet Pusher)
Model NPR-A
Series Ratchet and Other Tools
Product Description


WLL(TON)Working LengthAØBCWeight(kg)


A ratchet pusher used to adjust the interval of frames when attaching side frames to the outer plating and the inner bottom plating of a hsip.


- When operating the handle, the length of the NPR-A ratchet pusher gets longer as the pipe comes out by the functioning of the screw.
- NPR-A is an efficient ratchet pusher which is lighter and easier to be transported and simpler to operate than the existing HYD'JACK.
- The stopper type has the built-in pin to prevent the screw from completely coming out of a pipe.

How to use

After fixing the ratchet pusher between a tack welded frame(L- and T-section steel)  and a frame to be tack welded, push up or down the pawl according to purposes and then operate the handle.


- Do not exceed the rated capacity specified on the ratchet pusher.
- Be careful that the pusher can slip when the erected angle of the inner plating and the frame is more or less than 90°.
- For non-stopper types, leave at least 40mm of the screw thread inside one end of the pipe(80mm for both ends) when pulling the screw ouot f a pipe.

Products of Mag switch
Magswitch Magnets(Single Type Magnets)
Magswitch Magnets (Lifting Magnets & Heavy Duty Magnet Lifters)
용접 및 조선소용 치공구
플랜지 위자드
Welding & Shipbuilding Magnetic Tools