|Product Name||Induction Preheater|
The IP Series preheater has a wide range of applications. During the extrusion work for copper wire or non-steel sheath, you can use this preheater to improve quality and productivity.
During cable extrusion work, it can be used to preheat conductors as it is easy to use and has a simple structure.
Its offset function can be used to maintain a consistent temperature throughout all speeds.
For Cu wires with a diameter of less than 5mm, a manufacturing speed of 500mpm can be achieved.
It is firm and durable. The bottom pulley receives the line speed for detection purposes.
The system can control its output depending on each speed.
This is a preheater that can generate max output at the height of 1,000mm, line center.
It is frequently used for line speeds of 800rpm in automobile or electronic cable manufacturing facilities.
It has a top/bottom pulley with a diameter of 220mm. The top part has an insulated electrode wheel that is composed of closed circuits.
The bottom wheel has low heat conductivity and good insulation to minimize heat loss.
The top/bottom wheel has a diameter of 300mm, which makes it adequate for preheating lines with large curvature radius and thick copper wires.
It has a tall Line Center, so if you use an extruder line with 1,000mm, then you need to use the both wing’s guide roll to adjust the line center.
|MODEL||WIRE SIZE||TEMT SET RANGE||KVA||PULLY||MATERIA||LING SPEED|
|IP-150P2||02 ~0.9mm||299℃||2KVA 50/60Hz||150mmX2||CU||150m/m|