Chat with us, powered by LiveChat Screw Clamp | 매그스위치테크놀로지코리아 - 코머신
제품명 Screw Clamp
모델명 NPC-A
시리즈 Clamps
카탈로그
제품소개

NPC-A


WLL(TON)Jaw OpeningABCD1D2EFØGIØJKWeight(kg)
10-25303016825254698381725402.7
1.50-25253216625254698381828452.7
20-303035182252546100402030502.9
0-404530182252546103402030483.1
30-354038205303846116422236604.4
0-606540235304051121452236616.3
0-100105503233755601625030367516.1
50-5052522653550591525528407010.3
0-7075552953850621605530407012.0


No.ASS’Y NAMENo.PART NAMENo.ASS’Y NAMENo.PART NAME
1BODY--4BEARING ASS’Y4-1BEARING
2SCREW ASS’Y2-1SCREW4-2SPRING PIN
2-2HANDLE5END PLATE--
3SWIVEL JAW--6SNAP RING-

-



Features

- The NPC-A is a screw clamp used to prevent accidents caused by the widening, slipping or breakage of the hook because the load is
 concentrated  at the end of the hook when hanging the hook of a lever block and a chain block directly on a work piece.
- The NPC-A is a safe clamp designed to prevent a work piece from slipping  as the jaw opening of the clamp gets smaller by the slope which
  is proportional  to the load on the spherical swivel jaw built in the jig bearing which works as gearing on the opposite side of the screw.


How to use

Insert a steel plate into the inside end of the clamp's jaw opening and then completely tighten the screw.


Warnings

- Do not exceed the rated capacity specified on the clamp.
- Use a work piece only which falls within the jaw opening range specified in the instruction manual.
- If the load is placed laterally, not straightly, on the eye hole, use only 1/2 of the rated capacity.
- Never vertically erect a work piece with this model.
- For horizontal lifting, the clamping point must be two or more. When clamping, the clamps must face each other, not look in one direction.

매그스위치테크놀로지코리아의 제품들
매그스위치 자석류 (싱글타입 자석)
매그스위치 자석류 (대용향 리프터용 자석(직렬 배열형 자석))
용접 및 조선소용 치공구
플랜지 위자드
Welding & Shipbuilding Magnetic Tools