



A leading manufacturer of IP camera, Video Server and Zoom module
TCB-1236A
- 1/2“ Sony CMOS Sensor
- 36X Optical Zoom, 16X Digital Zoom
- Max 60FPS @ 1920 x 1080
- H.265 / H.264 / MJPEG
- Autofocus
- True WDR
- SRT (Secure Reliable Transport)
- RTSP/RTMP/MPEG-TS
- ONVIF, PSIA Compliant
Specifications
| Basic Specifications |  | 
| Image Sensor | 1/2” Sony CMOS Sensor | 
| Minimum Illumination | Color : 0.09 Lux at 1/30sec, 50IRE BW : 0.005 Lux at 1/30sec, 50IRE | 
| Analog Gain / Digital Max Gain | 1 to 30 | 
| Shutter Speed | 1/1 to 1/100000 | 
| Maximum Aperture Ratio | F1.4 ~ F4.9 | 
| Defog | YES | 
| Noise Reduction | 2D, 3D | 
| Gamma | 0, 1, 2, Auto(Normal), Auto(Clear), Auto(Bright), Auto(Fine) | 
| Wide Dynamic Range | Level 1 to Level 7 | 
| White Balance | Auto Tracing White, Auto White, Manual | 
| AE (Auto Exposure Mode) | Auto, Flat, Spot, Center | 
| Lens (wide to tele) | 36x optical zoom ; f= 6 mm to 216mm, F1.5 to F4.8 | 
| Digital Zoom | 16x | 
| Angle of View | Horizontal : 58.5°(wide) ~ °2.1(tele) | 
| Minimum Focus Length | 1 m to 10 m | 
| Video | 
 | 
| Compression | H.265/H.264/MJPEG | 
| Frame rate | Max 60fps @ 1920x1080 | 
| Bitrate | Primary : 32Kbps ~ 16Mbps, Secondary x3 : 32Kbps ~ 4Mbps | 
| Resolution | 352x240 ~ 1920x1080 | 
| Streaming | Primary : H.265/H.264, Secondary x 3 : H.265/H.264/MJPEG | 
| Burn-in OSD | Multi-lingual | 
| Audio | 
 | 
| Compression | G.711 / AAC | 
| Sampling rate | G.711 : 8 KHz, AAC : 32 kHz / 44.1 kHz / 48 kHz | 
| Bitrate | G.711 : 64Kbps, AAC: 64Kbps/128Kbps | 
| Streaming | G.711 : Full-duplex, AAC : Full-duplex | 
| Input/Output | 1 x Line-In (mono), 1 x Line-Out (mono) - IN / OUT Connector : 0.4mm PITCH CONNECTOR FOR 30pin MICRO COAXIAL CABLE (KEL) | 
| Network | 
 | 
| Protocol | IPv4/v6, TCP, UDP, IGMP(Multicast), ICMP, DHCP, HTTP, HTTP, FTP, SNMP, SMTP, UPnP, WS-Discovery, Zero Configuration, NTP, SRT, MPEG-TS, RTP, RTSP, RTMP, DDNS | 
| Security | Password protection, IP address filtering, HTTPS encryption, SRT | 
| API | Truen protocol/SDK, ONVIF, PSIA | 
| Interface | Ethernet 10/100/1000base-T / Connector : 1.25mm Conn - Connector : 1.25mm PITCH wire to board CONNECTOR (8pin of 12pin) | 
| Event and Alarm | 
 | 
| Event Source | Motion, Sensor input, Client disconnection, Intrusion, Line crossing, Tampering, Face detection, Sound detection, User defined event | 
| Event actions | Notification(E-mail), FTP, PTZ preset, Alarm control, Recording | 
| General | 
 | 
| Power Supply & Power Consumption | Min DC12V/1.5A & DC12V: Max 4.5W | 
| Operating Temperature | -10°C ~ 50°C ( 14°F ~ 122°F ) | 
| Operating Humidity | 20% ~ 80% RH | 
| Edge Storage | SD/SDHC/SDXC slot (Max 256GB) / Connector : Micro-Coaxial | 
| Dimensions (W x H x D) | 55.5mm X 124.3mm X 66.5mm | 
| Weight | 356.4g | 






| <Front> 
 | <Top> 
 | <Bottom> 
 | 
| <Rear> 
 | <Right side> 
 | <Left side> 
 | 
| R0M-J4 | |||||||
| Pin No. | Signal | Dir | Description | Pin No. | Signal | Dir | Description | 
| 1 | EXT_RTX+ | I/O | RS-485 + | 16 | 5V | PWR | DC 5V Output (Max 100mA) | 
| 2 | EXT_RTX- | I/O | RS-485 - | 17 | Reserved | I/O | Reserved | 
| 3 | AC_IN_L | I | Audio Line input | 18 | Reserved | I/O | Reserved | 
| 4 | AC_OUT_L | O | Audio Line output | 19 | GND | PWR | Ground | 
| 5 | IP_RESET | I | Factory reset Input(Active Low) | 20 | Reserved GPIO0 | I/O | GPO(For Alarm Output, 3.3V Signal output) | 
| 6 | DAC_CVBS | O | CVBS output | 21 | Reserved GPIO1 | I/O | GPI(For Sensor Input, 3.3V Signal input) | 
| 7 | Reserved | O | Reserved | 22 | 3.3V | PWR | DC 3.3V Output (Max 100mA) | 
| 8 | Reserved | O | Reserved | 23 | 3.3V | PWR | DC 3.3V Output (Max 100mA) | 
| 9 | Reserved | O | Reserved | 24 | SDIO0_DETECT | I | SDIO 0 card detection signal, active low | 
| 10 | Reserved | I | Reserved | 25 | SDIO0_CLK | O | SDIO 0 output working clock for the card | 
| 11 | INTER_Tx1 | O | Connect to INTER_Rx2 | 26 | SDIO0_CMD | I/O | SDIO 0 command | 
| 12 | INTER_Rx1 | I | Connect to INTER_Tx2 | 27 | SDIO0_DATA0 | I/O | SDIO 0 data 0 | 
| 13 | INTER_Tx2 | O | Connect to INTER_Rx1 | 28 | SDIO0_DATA1 | I/O | SDIO 0 data 1 | 
| 14 | INTER_Rx2 | I | Connect to INTER_Tx1 | 29 | SDIO0_DATA2 | I/O | SDIO 0 data 2 | 
| 15 | 5V | PWR | DC 5V Output (Max 100mA) | 30 | SDIO0_DATA3 | I/O | SDIO 0 data 3 | 
| R0M-J1 | |||
| Pin No. | Signal | Dir | Description | 
| 1 | NETWORK_D- | IO | Ethernet Negative Data 4 | 
| 2 | NETWORK_D+ | IO | Ethernet Positive Data 4 | 
| 3 | NETWORK_C- | IO | Ethernet Negative Data 3 | 
| 4 | NETWORK_C+ | IO | Ethernet Positive Data 3 | 
| 5 | NETWORK_B- | IO | Ethernet Negative Data 2 | 
| 6 | NETWORK_B+ | IO | Ethernet Positive Data 2 | 
| 7 | NETWORK_A- | IO | Ethernet Negative Data 1 | 
| 8 | NETWORK_A+ | IO | Ethernet Positive Data 1 | 
| 9 | VIN | PWR | Supply Voltage DC12V | 
| 10 | VIN | PWR | Supply Voltage DC12V | 
| 11 | GND | PWR | Ground | 
| 12 | GND | PWR | Ground | 














